You will receive 1 QT of FC710 and 1 1/2PT of FH611 Any questions please e-mail or call Cliffs Auto Parts at 1-800-287-6152 . 8 AM TO 6 PM Monday - Friday Saturday 9 AM TO 4 PM Cliffs Auto Parts 4727 Conowingo RD Darlington MD 21034 . Shipping is in continental US
NOT FOR SALE TO CALIFORNIA MARYLAND DELAWARE RESIDENCE
Due to the High VOC limits for California Maryland Delaware, check your location regulations to verify it can be used in your area.
Due to the High VOC limits for California Maryland Delaware, check your location regulations to verify it can be used in your area.
- 1 QT
- Mix 4:1 with hardener
- Made in the USA
Substrates:
FC710 can be applied over Basecoats or cured Single-Stage Enamels
Application:
- Apply 2 coats, allowing each coat to flash to hand-slick between coats or a wet-on-wet “limited flash” application can be used allowing a 2-5 minute flash between coats.
- Adjust air pressure to: HVLP 8 - 10 psi, Conventional 50 – 60 psi
ReCoat
- Basecoat: 10-15 minutes
- Single-Stage Enamels: 8 hours to overnight dry
- Clearcoat: Allow FC710 clearcoat to dry overnight, then scuff with 1000 grit and reapply clearcoat
Drying:
Air Dry Times at 70°F
- Dust Free: 15 minutes
- To Deliver: 4-6 hours
- Force Dry: 15 minutes @120°F surface temperature
Buffing:
If necessary, after 24 hours air dry, or cool down from force dry, sand with 1500 or finer grit paper and buff with the appropriate compound. Buffing is easiest when done within the first 48 hours following application.